![]() I will test them one a time and see if any work correctly. I will go through them and test one at a time, but am open to suggestions as to which of these controllers may be closest to the Fanuc Oi-MF. They have a few other Fanuc posts as well,Īre any of these posts worth trying? - just curious if anyone has an opinion or knowledge about this This is allowing me to use the machine until I get a better post configured (it puts G41 T3# on lines when it applies cutter comp, with the # being the actual tool number,Īnd I need to remove the 3 which is not too bad, not sure why it does this though) I have been able to post and run GCODE using a generic post called FANUCOM that comes with CAMWORKSīut I have to modify the code by hand to eliminate errors I am trying to locate or make a CAMWORKS 2019 post to run with a Doosan DNM-5700, with the Fanuc Oi-MF controller ![]() I am using Solidworks 2019 with Camworks 2019. Employment Opportunity / RFQ (Request for Quote).I have a Doosan DNM-5700 but am still working on getting a good post to work with my CAD/CAM Setup.Education - Teachers and Students Hangout. ![]() If you do have any questions for me, you can contact me directly at Regards, I didn't mean for the post to be an advertisement but rather a way to offer information to people that are looking for something extra. I hope this isn't taken as spam but rather my open thoughts on how the book was created. I use the reference portion of the book like I do the Machinery's Handbook. The point of the book is to have some lessons of "how to" and a to have a physical reference like the help file. I also read the help file regularly to find answers to my questions. ![]() I agree the manuals that come with CAMWorks are a valuable learning tool and I reference them regularly. As I wrote the book, I decided that the book should be available for everyone that needs help, not just the people I directly work with. When I transitioned into a tech guy for a CAMWorks reseller, I started to create a manual for my classes to help the new users I taught. I used it everyday and learned a lot of things the normal "trial by fire" way. I started using CAMWorks as a user in a small machine shop. I wanted to give a little insight as to why I put this book out for the public. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |